I have set up a dual bookmark in which one side there is a USB folder, and the other side I have mirror folder on HDD.
The idea is to plug in the USB and then load both folders quickly and sync them with F9.
If I use the command when the USB is not plugged in, x2 should show desktop and quickly end the command.
Instead, x2 hangs (the screen whites out). I have to kill x2 using task manager.
x2 hangs if bookmark target is a USB that is removed
Moderators: fgagnon, nikos, Site Mods
Re: x2 hangs if bookmark target is a USB that is removed
I just tested and it doesn't have any problems for inexisting drives!? Try a reboot
Re: x2 hangs if bookmark target is a USB that is removed
Indeed I checked on my office PC and it works as expected.
(if I remove the USB, it loads just the HDD folder and for the opposite pane says "cannot make sense of the input")
This is fine.
Will check the PC at home again.
Thanks!
(if I remove the USB, it loads just the HDD folder and for the opposite pane says "cannot make sense of the input")
This is fine.
Will check the PC at home again.
Thanks!
Re: x2 hangs if bookmark target is a USB that is removed
I restarted the home PC, and now x2 behaves as expected.
Thanks.
Thanks.