zabkat support forum

workround for this ?

did you see this blog? www.zabkat.com/blog/volume-mount-point-backup.htm

Sorry to resurrect this old thread, but my question is along the same lines as what the OP asked.

I'm going to be imaging my machine and converting it to a hypervisor, running my Windows install inside there as a VM, and the drive letters will obviously change. I was hoping to open actual drives in X² using VolID so those drives are always opened, regardless of what drive letter they may be assigned. The drives I'm referring to are not going to be formatted, so *should*, theoretically, retain their current VolIDs.

X² has 0 issues with junctions I've created that use the VolID as part of the path, but if I try to open a location in a new tab and try to use VolID, it simply refuses to open.

I created a dir on my D drive, under /mnt (lol Linux NE1?) and mounted my physical drive to the directory using the VolID _ it worked. But when I tried to reference it in X² in hte path, it would not load unless I specified the path to the folder itself. Which is counter-intuitive to what I want to achieve.

did you try "mounting" the drive onto a folder as explained in the above blog article?