When in dual pane view, with multiple tabs open in each pane (my normal, messy, workflow), if I accidentally switch to single pane then restore dual pane, all the tabs configured in the lower/right pane are gone.
Can the lower/right pane's tab configuration be retained when switched from dual to single so the configuration isn't lost but restored when returning to dual pane view?
----------------------
PJ in FL
Dual Pane to Single to Dual Loses the Configuration
Moderators: fgagnon, nikos, Site Mods
Re: Dual Pane to Single to Dual Loses the Configuration
you can try CUSTOMIZE > FOLDER GROUPS > STARTUP menu command, which will restore the tabs you had when you started the program
Re: Dual Pane to Single to Dual Loses the Configuration
I use folder groups on a regular basis to save bottom/right pane configurations. It's the times when I haven't saved the pane config and accidentially hit ctrl-O(uch) by mistake that are the issue.
Deleting the configuration information seems extreme.
Again, can the program save the configuration and restore it back to the last saved folders / tabs when going from the (almost never used) single pane configuration back to the dual pane configuration?
If so, will you implement it in the next beta?
------------------------------
PJ in FL
P.S. - I miss K. He'd pop in about now to mediate between us....
Deleting the configuration information seems extreme.
Again, can the program save the configuration and restore it back to the last saved folders / tabs when going from the (almost never used) single pane configuration back to the dual pane configuration?
If so, will you implement it in the next beta?
------------------------------
PJ in FL
P.S. - I miss K. He'd pop in about now to mediate between us....
Re: Dual Pane to Single to Dual Loses the Configuration
I did it already!