Hi Nikos,
In X2 0.0.0.57, I tried to set the timestamp of a file using "Change Attributes" dialog (Shift-F12). I was unsure how to specify the AM or PM part. Can you please advise?
For instance, if I enter "10" for the hour, would that be AM or PM?
Thanks
How to specify AM & PM for Change Attributes feature?
Moderators: fgagnon, nikos, Site Mods
Hi vserghi,
You are right that my system is having 12hr time format. I am not allowed to enter 22 in the hour field.
I think your workaround should work. But I am trying not to use the 24hr time format
I found another work around though to choose AM or PM in 12hr format.
1) Enter a value for hour field, say 10.
2) Accept it and check the resultant timestamp.
3) If it's incorrect, perform 1) again and scroll up/down to the other value 10.
4) Accept it and bingo!
Thanks
You are right that my system is having 12hr time format. I am not allowed to enter 22 in the hour field.
I think your workaround should work. But I am trying not to use the 24hr time format
I found another work around though to choose AM or PM in 12hr format.
1) Enter a value for hour field, say 10.
2) Accept it and check the resultant timestamp.
3) If it's incorrect, perform 1) again and scroll up/down to the other value 10.
4) Accept it and bingo!
Thanks