how to save scrap pane layout or what up with these dual panes?

[FrizzleFry]

since I installed the last version the scrap windows in one of my layouts start out as dual panes... I prefer just a single pane for scraps but neither save settings now nor save settings on exit is saving the scrap layout as single pane...

this is with 3.5.0.1 ultimate

[nikos]

the secret with scraps is to have them filled with items and then settings will stick when you close them

[FrizzleFry]

does not make a difference if I have 1 item in a scrap or many... it just continues to start as dual pane...
is there a setting I can manually adjust in the ini file to disable dual pane in scraps?

[xplorer2_UC.working\ScrapFrame Settings]
@=
binDockStyle=0
binDockSite=2244608
binDualPaneFlags=0

is this the setting for dual pane in a scrap?

BTW, it is saving the state of tile horizontally but no matter what I have tried dual pane always starts checked.

I think I see what the deal is... I usually start this layout like this...

C:\tools\xplorer2_ultimate\xplorer2_64.exe /S:working "$L" "$R"

C:\tools\xplorer2_ultimate\xplorer2_64.exe /S:working foldergroup1 foldergroup2

so I guess sending folder info for both main panes forces the scraps to start dual pane

if I only send one folder or group or do not send any folders the scraps start with a single pane

This is relatively new behavior because I have been starting this layout as mentioned above for years and have not been getting dual pane scraps.

[nikos]

right this is an unintended consequence of a change I did for the main window, I'll fix it

[FrizzleFry]

thanks

[nikos]

in the meantime you can maximize one of the 2 scrap panes with ctrl+E or just with the splitter so it doesn't get in the way too much

[FrizzleFry]

This "unintended consequence" also seems to affect launching layouts.

I have a layout called columns that usually only has one pane but if I launch it from a window started as mentioned above (passing folder info for both panes) the columns window will be dual panes.

What I am doing for now is using unchecking tile horizontally so I get the full width of the pane. Thanks for the reminder of Ctrl+E.